Omni-Clean SD is a super-heavy duty general purpose product used in a variety of cleaning applications, including high pressure or low-pressure spraying, steam-cleaning and manual cleaning and degreasing. The product effectively removes oil stains from concrete, and grease and oil build-up from clothing, equipment, engines and all types of machinery. Omni-Clean SD creates no adverse health effects for users. Its uses also include cleaning pots and pans, floors, laundry as well as general purpose cleaning. Omni-Clean SD can reduce chemical use hazards (including associated liability) and increase safety and efficiency while reducing costs. This product has been USDA accepted for certain uses and is presently being sold to hotels, restaurants, fast food chains, laundry services, oilfield and janitorial service companies.
EPA 796.3100 40 CFR CHAPTER 1, SUBPART D, AEROBIC AQUATIC BIODEGRADATION
Determines the rate and extent of aerobic biodegradation that might occur when chemical substances are released to aquatic environments. The test requires a rate of at least 70% biodegradation at the end of 28 days for a substance to be deemed “readily biodegradable”.
The biodegradation rate of Omni-Clean-SD as tested to this protocol is 95.5% in 28 days.
EPA 600/4-82-057 METHODS 601, 612, 624 AND 625-METHODS FOR ORGANIC CHEMICAL ANALYSIS OF MUNICIPAL AND INDUSTRIAL WASTEWATER
Determines the presence of purgeable halocarbons, chlorinated hydrocarbons, purgeables (volatiles), base/neutral extractables, acid extractables, pesticides and PCBs.
Omni-Clean-SD contains no detectable levels of the listed organics.
BASE/NEUTRAL/ACID BY GC/MS, METHOD 625
Determines whether the finished product or individual constituents of the tested compound transition through a toxic phase during the biodegradation process.
Omni-Clean-SD showed less than Minimum Detectable Limits (MDL) for all of the Base/Neutral/Acids.
ASTM F-483 IMMERSION CORROSION
Determines the effect of a material on various types of metal.
Omni-Clean-SD is non-corrosive to the following metals: aluminum cadmium plated steel, titanium, magnesium and 1020 steel.
ASTM F-519 HYDROGEN EMBRITTLEMENT
Determines if a material causes embrittlement of metal
Omni-Clean-SD does not cause stress crazing of acrylic or polycarbonate plastic.
ASTM F-502 PAINT SOFTENING TEST
Determines the effect of a material on painted surfaces.
Omni-Clean-SD does not cause a decrease in film hardness, discolor or stain painted surfaces.
BMS 1-59 RUBBER TEST – ELASTOMER DEGRADATION TEST (SEALANT TEST)
Determines the effect of materials on sealants.
Omni-Clean-SD does not cause lifting at edges and does not cause adhesive failure of rubber sealants.
ASTM D-56 TAG CLOSED CUP TEST FOR FLASH POINT
Determines the flash point of a material
Omni-Clean-SD has no flash point to boil (212¾ F); no flash detected when allowed to boil three minutes.
ASTM D-92 CLEVELAND OPEN CUP FOR FLASH POINT
Determines flash point of a material.
Omni-Clean-SD has no flash to boil (212_ F).